|
Product Details:
|
| Application: | Open Hole Drill Stem Testing | Type: | Open Hole Tester Valve |
|---|---|---|---|
| Working Pressure: | 15000 Psi | Tool Size: | 5 Inch |
| Connection: | IF Box X Pin | Working Condition: | H2S Above 175oF |
| Material: | AISI Alloy Steel | Package: | Polywood Case |
| Highlight: | downhole tools,dst well test |
||
ISO BV Approve Open Hole DST Tester Valve Dual Control Valves 70 Mpa
Introduction of Open Hole Multi-Flow Evaluator
The Multi-Flow Evaluator, which has dual control valves, is sequentially opened and closed by up and down motion of the drill stem, the MFE is in the closed position going in the hole and is opened with a time delay, by applying weight to the drill stem when bottom is reached .Following this delay the drill stem drops rapidly one inch, indicating opening.
To close the MFE the drill stem is picked up through the free point and moderate tension is applied, then weight is set back down. To re-open the MFE the same operation of up and down motion is repeated. The unlimited number of shut-in and flow periods gives additional information for chart analysis.
The Multi-Flow Evaluator’s dual control valves trap a sample of flowing fluid at the end final flow period. This sample is brought to the surface under pressure with the string of tools. A choke retainer in the top sub allows flexibility in bottom choke size.
Specification of Open Hole Multi-Flow Evaluator
| No | Specification | 5” |
| 1 | OD | 127.5mm |
| 2 | Length(mm) | 3102mm |
| 3 | Working pressure | 70Mpa |
| 4 | Tensile strength(yield) | 1868.8kN |
| 5 | External yield pressure | 22000psi |
| 6 | Torque strength | 20000psi |
| 7 | Flow area | 1200mm2 |
| 8 | Service Environment | Mud, crude oil, natural gas with H2S,apply to NACE MR0175-2002 |
| 9 | End connections | 3 1/2 IF. B X 3 1/2 IF.P(with crossover) |
| 10 | Service Temperature | -20oF~+400oF |
Constructure of Open Hole Multi-Flow Evaluator
The MFE consists of three basic sections: indexing, delay, and sampling. Each of these sections will be described in detail below.
Indexing Section
The indexing section consists of three basic parts: Spline Mandrel, Spline Sleeve, and J-Pin, The function of the indexing section is to sequentially open and close the testing valve as the spline Mandrel is moved up and down.
Delay Section
The “opening indication” mentioned above is incorporated into the delay system. The MFE incorporates a delay system similar to a conventional hydraulic tool: the hydraulic delay is effective when slacking down, but “disengaged” while picking up.
Sampler Section
The sampler section is a full flow-through type. All of the formation fluid passes through the sampler before entering the drill pipe when slacking down, but “disengaged” while picking up.
About Techcore Oil Tools
Techcore Oil Tools expertise in manufacture of the Drill Stem Testing Tools for more than Ten years, the professional Reserch and Development (R&D) department improves the advanced technology in design of the Drill stem testing tools for well testing service.
We approach every client’s enquiry with meticulous attention to technical specifications, and a high level of appreciation for their urgency.
Welcome to contact us for more information about our tools and service!
Contact Person: Mr. LEE
Tel: 0086 18161839623
